CE Buyers Guide
German
MicroMax®
Lakeland’s MicroMax® line provides quality, single-use protective clothing for most industrial applications.
A range of disposable garments based on high-quality microporous film for lightweight protection, this disposable garment guards against dust and light aerosol liquid sprays. A combination of two-layer spunbonded polypropylene with flexible microporous polyethylene results in soft, Lakeland MicroMax has a flexible fabric with high-level liquid and dust repellency.
An additional polyester scrim is laminated between the film and polypropylene substrate to act as a “rip-stop” and add additional strength providing the highest tear strength available for disposable protective garments.
An additional polyester scrim is laminated between the film and polypropylene substrate to act as a “rip-stop” and add additional strength – some of the highest tear strength available for Type 5/6 coveralls.
The film-based surface is low-linting and is ideal for paint-spraying or similar applications.
CE Buyers Guide
English
CE Buyers Guide
Spanish
Products Catalog
Chinese
Disposable and Chemical Protective Clothing
English
MicroMax® Data Sheet
German
MicroMax® Data Sheet
Spanish
MicroMax® Data Sheet
Dutch
Please Note:
All test results quoted are from testing carried out at independent laboratories to the relevant {ASTM/CE} Standard(s). Unless stated otherwise tests are carried out on samples of the relevant protective material as opposed to finished garments. Note that all testing is conducted at specific temperatures according to ASTM or EN standard requirements. As permeation is affected by temperature it is important to consider the likely temperature in any application. Permeation test results record a time to a specific permeation rate as defined by the relevant standard and NOT a time to initial breakthrough of the chemical. Also note that differences may be apparent in some cases between CE and ASTM test results. Whilst the tests are similar, the CE standard records a time to a permeation rate of 1.0µg / min / cm2, whilst ASTM records a time to a permeation rate of 0.10µg / min / cm2. This may explain differences between results. As with all Personal Protective Equipment, selection should be based upon the end users risk assessment, it is the responsibility of the end user to determine the suitability of any PPE as part of this risk assessment and to comply with any/all legislative/governmental requirements. Contact Lakeland for more information.